DELL OPTIPLEX GX260 MULTIMEDIA AUDIO CONTROLLER DRIVERS DOWNLOAD

If you are installing a replacement drive and the new drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws that secure each rail to the drive. Page 29 some protection from dust, fingerprints, and scratches. Click the Start button and click Control Panel. Page – reinstalling windows xp Page Page – system board Page Page Page Page – jumper settings Page Page – replacing the system board Page Page Page Page Page – about your small desktop computer Page Page Page Page – attaching and removing the computer stan If an admin password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion detector. When the Regional and Language Options screen appears, select the settings for your location and click Next. Press on the card lever away from the card connector.

Uploader: Nashakar
Date Added: 17 July 2014
File Size: 53.90 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 30930
Price: Free* [*Free Regsitration Required]

Page the card by its top corners, and ease it out of its connector.

Cover was previously removed. Page After you open and close the cover, the chassis intrusion detector, if installed and enabled, causes the following message to appear on the screen at the next dell optiplex gx260 multimedia audio controller start-up: For information on the type of memory supported by your computer, look under “Memory” in “Specifications.

If you are removing the card permanently, install a filler bracket in the empty card-slot opening. There is no match for that Service Tag or product ID.

If you are installing a replacement drive and the dell optiplex gx260 multimedia audio controller drive does not have the congroller rails attached, remove the rails from the old drive by removing the two screws that secure each rail to the drive. Information in this document is subject to change without notice. Run the Dell Diagnostics to identify a more serious cause. For information about the Dell warranty for your computer, see the Product Information Guide del separate paper warranty document that shipped with your computer.

Service Tag — A dell optiplex gx260 multimedia audio controller code label on your computer that identifies delk computer when you access Dell Support at support. Leave the release lever extended in fell release position so that the socket is ready for the new processor. The pin-1 end of a connector on a board or a card is usually indicated by a silk-screened “1” Ensure that your computer and attached devices are turned off. Grasp the serial port adapter by its top corners, and ease it out of its connector.

Page 10 Security security options. Partition and logically format your drive before you proceed to the next step.

Dell GX280DT – GX280 Desktop Computer User Manual

Don’t show me this message again. If the drive dll just installed is the primary drive, install your operating system on the hard drive.

Lower the retention arm and press it into place. Contact Dell for technical assistance. Install the new system battery. Page of Go.

Test the hard drive by running the Dell Diagnostics. If you need assistance in determining which codes to use, contact a local or an international operator. If necessary, disconnect any cables connected to the adapter.

Move the first hard drive from the upper bay to the lower bay: A connector on the system board in some computers where you insert an expansion card, connecting dell optiplex gx260 multimedia audio controller to the system bus.

Welcome to Dell Support

See the documentation for your operating system for instructions. Mouse Port option is set to On.

The following information is provided on the device or devices covered in this document in compliance with FCC regulations: Installing A Pci Express Card 5. Gently slide the chassis myltimedia switch into its slot and reconnect the cable to the system board.

Follow the procedures in “Before You Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide. Orange — A good connection exists between a Mbps network and the computer. These identifiers are usually found on the back or bottom of your device.

Page 1 interface connector 2 dell optiplex gx260 multimedia audio controller cable 3 colored stripe on IDE cable Most interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one connector matches a tab or a filled-in hole on the other connector. Product Information If you need information about additional products available from Dell, or if you would like to place an order, visit the Dell website at www. Follow the instructions on the optipleex.

Page Small Desktop computer: Page connector data width maximum 32 bits PCI Express connector one x1 and one x16 connector size 36 pins x1 and pins x16 connector data width maximum one PCI Express lane x1 and 16 PCI Express lanes x16 Mini-Tower full-height cards supported Enter system setup and use the Diskette Drive option to enable your new floppy drive.

If possible, do not pair an original memory module with a new memory module. Each device has its own set of specialized commands that only its driver recognizes.

Three types of modems include: Remove the interposer board from the dell optiplex gx260 multimedia audio controller. Page 81 A device that allows your computer opptiplex communicate with other computers over analog telephone lines.

If your computer and attached devices did not automatically turn off when you shut down your computer, turn them off now. Use a small flat-edge screw driver on the backside of the panel insert to gently pop off the insert.

DELL GXDT – GX DESKTOP COMPUTER USER MANUAL Pdf Download.

Table of Contents Add delll my manuals Add. Grasp the serial port adapter bracket by its top corners, and ease it out of its connector. A computer may include a network adapter on its system board, or it may contain a PC Dell optiplex gx260 multimedia audio controller with an adapter on it. At the Computer Name and Administrator Password window, enter a name for your computer or accept the one provided and a password, and click Next.